INSTRUMENTATION TUTOR FOR PRESSURE MEASUREMENT (P–12)


DESCRIPTION   : 

Pressure is basically a mechanical concept that can be expressed in terms of divisions of mass & length. The conventional pressure transducer are designed based on simple physical principles to meat the required of the end user. In all cases the ideal transducer is are which can be installed a clearly discernible and pre die table electrical output is dependent safely on the input pressure and is capable of operating under a variety of environmental  conditions.  
  1. Lower  than  the  atmospheric  pressure  and extending  to  very  low  values,  designated  as  negative  gauge  pressure  or  vacuum.

  2. Above  the  atmospheric  pressure  and  relative  to it  (known  as  gauge  pressure)

  3. Very  high  pressure  expressed  in  atmospheres. 

THE  SET – UP  CONSISTS  OF  : 

Pressure  Sensor        :           Strain  Gauge  based.

Range                         :           0 – 1 Kg / cm2.

Maximum  Capacity    :           2 Kg / cm2.

Indicator                      :           3 ½  Digits digital mill volt with LED  Display.

Fluid                            :           General  purpose  Mobil  oil  is  used.

Weight                         :           1 Kg. Approximately

Dimension                   :           195mm x 315mm x 75mm 

EXPERIMENT   : 

            To  study  the  Pressure  Measurement  set – up.       

 

Note: There may be any change in specification due to continuous R & D without notice.

 

Click below to view catalogue